Calibration Technician Resume Example

Updated on: April 26, 2018

There is no way that you can get away with not writing a resume.

Since you have to make sure that you write one, it is best to start off on the right foot.

Here is a sample for you to go through before you write your own:





Calibration Technician Resume Sample




Eric Clam
77 East Drive, Lawton, OK 08246
(000) 999-9999


Extensive comprehension of maintaining, testing, and repairing a variety of instrumentation and equipment. Effectively able to handling testing activities, aimed at obtaining accurate results. Demonstrated ability to perform calibration of medium to high-level equipment types.


Intrinsic Calibration Procedures Development Maintenance
Troubleshooting Data Recording Conditions Handling
Equipment Adaptation Error Correction Reporting
Uncertainty Evaluation Training Engineering Liaison

• Successfully calibrated an exceptionally difficult to manage equipment, which had been in limbo for 4 months.
• Implemented a real-time error correction system, which resulted in a decrease in time that it took to correct errors on the spot.
• Simultaneously handled 3 out of tolerance conditions, by implementing advanced comprehension of diagnostic and calibration procedures.
• Trained over 20 personnel to work as calibration technicians, as part of their induction procedures.


Calibration Technician
Lockheed Martin, Lawton, OK | 2012 – Present
• Inspect systems to determine their calibration requirements, and assess work paths.
• Calibrate assigned equipment at the beginning of each shift to ensure that it works correctly.
• Evaluate the need for repair of electronic test equipment, after failed calibration attempts.
• Document all calibration activities, by following predefined processes and procedures.
• Manage repair and calibration of assessment tools, and streamline and update all assigned systems.
• Plan and execute sequences of testing and calibration programs, according to blueprints, and schematics.
• Perform analysis and conversion of test data, using a wide variety of mathematical formulas.
• Create and submit reports of successfully performed testing and calibration activities, for review purposes.

Calibration Technician
Sears Inc., Lawton, OK | 2007 – 2012
• Assisted technicians in calibrating assigned equipment, to ensure proper daily runs.
• Performed preventative and corrective maintenance on assigned equipment, as per instructions.
• Assisted with equipment installation, and repair techniques, by following set orders.
• Ensured that calibrated systems were properly operational, by checking them on a constant basis.
• Provided support in the setup of testing and calibration equipment, and recording test results.

Lawton High School, Lawton, OK
High School Diploma